Terraza FWD V6-3.5L VIN 8 (2005)
Brake Hose/Line: Service and Repair
Brake Hose Replacement - Rear (Disc Brakes)
Brake Hose Replacement - Rear (Disc Brakes)
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove tire and wheel assembly.
3. Clean all dirt and foreign material from the brake hose and the brake pipe fittings.
4. Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and contamination.
Use a backup wrench on the hose fitting, disconnect the brake pipe fitting from the brake hose, then cap or plug the brake pipe fitting end.
5. Important: Do not bend the brake pipe or the bracket.
Use a flat-bladed tool in order to remove the brake hose retainer clip (6) from the brake hose (2) mounting bracket.
6. Remove the brake hose (2) from the brake hose bracket (4).
7. Remove the brake hose bolt (1) from the brake caliper.
8. Remove the brake hose (2) from the brake caliper.
9. Remove and discard the 2 copper brake hose gaskets (3). These gaskets may be stuck to the brake caliper and/or the brake hose end.
10. Install a rubber plug into the brake hose bolt hole of the brake caliper in order to prevent brake fluid loss and contamination.
Installation Procedure
1. Remove the rubber plug from the brake caliper.
