Terraza FWD V6-3.5L VIN 8 (2005)
2. Install the upper intake manifold gaskets.
3. Install the upper intake manifold.
4. Apply Threadlocker GM P/N 12345382 (Canadian P/N 10953489) to the upper intake manifold bolt threads.
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the upper intake manifold bolts and the stud.
^
Tighten the bolts and the stud to 25 Nm (18 ft. lbs.).
6. Install the generator bracket.
7. Install the EGR valve.
8. Install the MAP sensor bracket and the sensor.
9. Install the EVAP canister purge solenoid valve.
10. Install the ignition coil bracket with the coils.
11. Install these wiring harnesses to the retainers:
^
Engine wiring harness
^
Left side spark plug wire harness
^
CMP sensor wiring harness
12. Install the left side spark plug wires to the spark plugs.
13. Install the air cleaner intake duct.
14. Connect these electrical connectors:
^
EVAP canister purge valve
^
Electronic throttle control
^
MAF sensor
^
EGR valve
15. Install the vacuum hoses at:
^
Brake booster
^
EVAP canister purge valve
16. Connect the negative battery cable.
17. Fill the cooling system.
