Terraza FWD V6-3.5L VIN 8 (2005)
Air Bag(s) Arming and Disarming: Service and Repair
SIR Disabling and Enabling Zone 6
SIR DISABLING AND ENABLING ZONE 6
DISABLING PROCEDURE
IMPORTANT: Refer to SIR Service Precautions.
1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition switch.
4. Open the hood and locate the underhood fuse center.
5. Lift the cover for the underhood fuse center.
6. Locate and remove the air bag fuse from the underhood fuse center.
IMPORTANT: With the Air Bag Fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation, and does not
indicate an SIR system malfunction.
7. Remove the passenger/right lower center pillar trim cover.
8. Loosen the right side impact sensor (SIS) fasteners, then slide right SIS (1) up and remove from center pillar.
9. Remove the connector position assurance (CPA) (3) from the SIS connector (2).
10. Disconnect the SIS wiring harness connector (2) from the SIS (1).
11. Remove the CPA from the passenger/right seat belt retractor pretensioner connector.
12. Remove the vehicle wiring harness connector from the right seat belt retractor pretensioner.
ENABLING PROCEDURE
1. Remove the key from the ignition.
