Terraza FWD V6-3.5L VIN 8 (2005)
1. Install the cooler pipe to the vehicle and the frame retainers.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the cooler pipe retainer to the frame.
^
Tighten the cooler pipe retainer bolt/screw to 10 Nm (89 inch lbs.).
3. Connect the cooler pipe to the steering gear.
^
Tighten the fitting to 27 Nm (20 ft. lbs.).
4. Install the power steering gear hose clip.
5. Connect the power steering return hose to the cooler pipe.
6. Raise the frame rear position.
7. Install the rear frame bolts.
^
Tighten the bolts to 165 Nm (122 ft. lbs.).
8. Remove the utility stand.
9. Connect the intermediate shaft to the steering gear.
10. Install the right side engine splash shield.
11. Lower the vehicle.
12. Bleed the power steering system.
