Terraza FWD V6-3.5L VIN 8 (2005)
Power Sliding Door Module: Service and Repair
Motor Clutch Replacement - Power Sliding Door (With RPO E59 LH)
MOTOR CLUTCH REPLACEMENT - POWER SLIDING DOOR (WITH RPO E59 LH)
REMOVAL PROCEDURE
1. Disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
IMPORTANT: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door
modules (PSDM) will be interrupted and both PSDs will be inoperative.
2. Remove the left body side trim panel.
3. Open the sliding door 1/3 of the way.
4. Support the bottom of the sliding door.
5. Remove the center roller bracket pin. Separate the center roller bracket, body side, from the center roller bracket, door side.
6. Position the bottom of the sliding door out at the rear in order to provide access to the center roller bracket, body side.
7. Remove the sliding door center track cover.
8. Position the sliding door center roller bracket, body side, at the front of the center roller track.
9. Manually pull the forward cable (1) in order to release the cable barrel from the sliding door bracket.
