Terraza FWD V6-3.5L VIN 8 (2005)
14. Adjust the cable tension. Refer to Cable Tension Adjustment - Sliding Door.
IMPORTANT: Ensure that the power sliding door cable barrels are properly installed into the sliding door center roller bracket, body side, cable
retaining fingers located on the roller bracket.
15. Manually open and close the sliding door in order to verify that:
-
Latch/unlatch function operates
-
Cable assembly is correctly positioned in the center track
-
The door fits, check all external door gaps
-
Ensure the lower roller track is clear of any foreign material and debris.
-
Ensure the fuel filler door is in the closed position.
16. Install the left body side trim panel.
17. Enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
IMPORTANT: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Actuator Control Module - Power
Sliding Door (PSD) Programming and Setup.