Terraza FWD V6-3.5L VIN 8 (2005)
2. When enabling the side impact module - RF proceed to step 17, if the entire SIR system needs to be enable then go to step 3.
3. Connect the vehicle wiring harness connector to the left seat belt retractor pretensioner.
4. Install the CPA to the left seat belt retractor pretensioner connector.
5. Install the left lower center pillar trim cover.
6. Connect the steering wheel module coil yellow connector (1).
7. Install the CPA to the steering wheel module coil connector (1) located at the base of the steering column.
8. Install the left I/P insulator panel.
9. Connect the vehicle harness connector (4) to the LF side impact module yellow connector (1).
10. Install the CPA to the LF side impact module connector (1).
11. Connect the I/P module yellow connector (1).
12. Install the CPA (2) to the I/P module connector (1).
13. Install the right I/P insulator panel.
