Terraza FWD V6-3.5L VIN 8 (2005)
Steering Angle Sensor: Service and Repair
Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement
Removal Procedure
Caution: Refer to Restraint System in Service Precautions.
1. Disable the SIR system. Refer to Restraint System Disabling and Enabling Zone 3.
2. Remove the steering column from the vehicle.
3. Remove the intermediate shaft from the steering column.
Important: Do not apply force to the sensor and the bearing assembly in a sideways direction.
4. Remove the sensor electrical connector by using a suitable tool in order to pull the connector down around the right side of the steering column for
accessibility.
5. Remove the sensor retainer from the steering shaft.
Important: When reusing the sensor (1) you must install a pin into the sensor before it is removed from the steering shaft. By not installing a pin
into the sensor it will cause the sensor to lose its centering position and must be discarded.
6. Pin diameter must be in the range of 1-2 mm.
Do not remove the bearing adapter (3).
If reusing the sensor (1), remove the position sensor by pulling the sensor straight out from the bearing adapter (3) until the sensor is almost off the
steering shaft (2). Install a pin into the sensor before removing from the steering shaft (2). Do not remove the pin until the sensor is re-installed.
7. If replacing the sensor (1), remove the sensor by pulling the sensor straight out from the bearing adapter (3) and off the steering shaft.
Installation Procedure
Important: A new sensor must come with a pin installed. If pin is not installed, return and reorder sensor.
Important: Do not apply force to the sensor (1) or the bearing adapter (3) in a sideways direction.
1. If reusing the sensor, with the pin still installed, align the sensor onto the steering shaft (2) and into the bearing adapter (3).
Important: If installing a new sensor the sensor will come precentered. Do not remove the pin until installation is complete.
2. Install the sensor onto the steering shaft (2) and into the bearing adapter (3).
3. The sensor must be set to approximately 3 mm gap between the sensor and the bearing adapter.
4. Install the sensor connector.