Terraza FWD V6-3.5L VIN 8 (2005)
2. Install the outer tie rod (2) to the steering knuckle (1).
Important: This is a prevailing torque type fastener. You may reuse this fastener ONLY under the following conditions:
^
The fastener and its counterpart are clean and free from rust.
^
The fastener develops 2 Nm (18 inch lbs.) of torque/drag against its counterpart prior to the fastener seating.
If the fastener does not meet these criteria, REPLACE the fastener.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Ensure that 2.5-4.5 tie rod end threads are visible beyond the tie rod nut nylon.
3. Install the tie rod ball stud nut.
^
Tighten the tie rod ball stud nut to 30 Nm (22 ft. lbs.) + 120 degrees .
4. Inspect and adjust the toe as necessary.
