Terraza FWD V6-3.5L VIN 8 (2005)
Notice: Refer to Fastener Notice in Service Precautions.
2. Install NEW wheel bearing/hub bolts.
^
Tighten the NEW wheel bearing/hub bolts to 130 Nm (96 ft. lbs.).
3. Install the wheel drive shaft nut.
4. Install the brake rotor.
5. Install the brake caliper bracket with the brake caliper.
Important: Ensure that the connector clip engages the bracket properly.
6. Install the wheel speed sensor electrical connector to the bracket.
7. Connect the wheel speed sensor electrical connector (2).
8. Install the tire and wheel.
9. Lower the vehicle.
Wheel Stud Replacement
Wheel Stud Replacement
^
Tools Required
-
J 35917Ball Joint Remover
Removal Procedure
Caution: If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s) or the wheel bolt(s), install only new GM original equipment
parts. Installation of used parts or non-GM original equipment parts may cause the wheel to loosen, loss of tire air pressure, poor vehicle
handling and loss of vehicle control resulting in personal injury.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
