Terraza FWD V6-3.5L VIN 8 (2005)
1. Install the servo spring.
2. Install the servo piston assembly.
3. Install the forward servo cover O-ring.
4. Install the forward servo cover.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the forward band servo cover bolts.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
6. Remove the drain pan from under the forward servo cover.
Important: Ensure that the power steering cooler line does not become trapped or damaged during this step.
7. Use the utility stand in order to raise the frame rear.
8. Install the NEW frame bolts.
9. Adjust the utility straps as necessary in order to align the powertrain mounts with the frame.
10. Install the transaxle mount nuts.
11. Install the engine mount nuts.
12. Install the power steering gear to the frame.
13. Install the power steering gear heat shield.
14. Install the stabilizer shaft.
15. Lower the vehicle.
16. Remove the engine support fixture.
17. Adjust the fluid level. Refer to the following information:
^
Transmission Fluid Checking Procedure
^
Fluid and Lubricant Recommendations.
^
Capacities - Approximate Fluid.
