Terraza FWD V6-3.5L VIN L (2006)
Sliding Door Handle: Service and Repair
Sliding Door Inside Handle Replacement
Inside Handle Replacement - Sliding Door
Tools Required
J 42506-A Sliding Door Handle Clip Remover
Removal Procedure
Important: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door
modules (PSDM) will be interrupted and both PSDs will be inoperative.
1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
2. Use J 42506-A in order to remove the inside door handle clip.
3. Remove the inside handle from the sliding door.
Installation Procedure
1. Load the clip into the inside door handle with the open end facing up.
2. Align the handle with the shaft on the sliding door.
3. Press firmly in order to seat the inside handle to the sliding door.
Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Acutator Control
Module - Power Sliding Door (PSD) Programming and Setup.
4. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
