Terraza FWD V6-3.5L VIN L (2006)
1. Install the power steering gear through the vehicle left side wheel opening to the frame.
2. Install the power steering gear bolts.
3. Important:
This is a prevailing torque type fastener. This fastener may be reused ONLY if:
-
The fastener and its counterpart are clean and free from rust
-
The fastener develops 2 Nm (18 inch lbs.) of torque/drag against its counterpart prior to the fastener seating.
If the fastener does not meet these criteria, REPLACE the fastener.
Notice:
Refer to Fastener Notice in Service Precautions.
Install the power steering gear nuts.
Tighten the power steering gear nuts to 60 Nm (44 ft. lbs.) plus 60 degrees.
4. Install the power steering gear heat shield.
5. Connect the power steering gear pressure hose to the power steering gear.
Tighten the fitting to 27 Nm (20 ft. lbs.).
6. Connect the power steering gear cooler pipe to the power steering gear.
Tighten the fitting to 27 Nm (20 ft. lbs.).
7. Install the power steering gear cooler pipe retaining clip.
8. Use the utility stand in order to raise the frame and the powertrain.
9. Install the frame rear bolts.
Tighten the bolts to 165 Nm (122 ft. lbs.).
