Allante V8-273 4.5L (1991)
9.
Position pedestal fan as show in Figure 2 and turn on high to provide cross ventilation during cleaning procedure.
10.
Use Kent - Moore tool J - 36645, or equivalent, siphon - type parts cleaning spray can capable of delivering two ounces per minute of liquid when
driven wit shop air at 80-90 psi. Insert the nozzle of the spray gun through the power module opening and insert the siphon hose into container of
disinfectant. Take care to place the bottle of disinfectant in a secure, upright position to avoid spilling the contents. Direct spray toward evaporator
face taking extra care to ensure adequate coverage of the corners and edges, completely saturating the entire core. Use the entire container of
solution.
CAUTION:
Do not allow disinfectant to come in contact with hot engine components such as the exhaust manifold as this may result in toxic fumes.
11.
Reach into the vehicle and turn the ignition to the off position, and allow the core to soak for five minutes.
12.
Reach into vehicle and start engine.
13.
Thoroughly rinse the evaporator core with one quart of clean water using the spray gun to rinse any disinfectant residue.
14.
Reach into the vehicle and turn the ignition to the off position and then reinstall power module.
CAUTION:
Care should be taken in handling the power module to prevent burns or personal injury from the heat sink which may be hot.
15.
Dispose of disinfectant and rinse water runoff collected in drain pan into a sanitary drain system.
16.
Disconnect battery charger.
