Allante V8-273 4.5L (1991)
18. Wire loom and vacuum hoses from clips on cradle and wire loom clip from transaxle mount.
19. A.I.R. pipe to hose end connections, pipe retainer at rear of cradle (not necessary to remove pipe from left cradle member).
20. Lower vehicle.
21. Raise engine/transaxle two inches using 2 support fixture hooks at flywheel side of engine.
22. Raise vehicle.
23. #1 insulator bolt and left cradle assembly (separate right front corner first).
24. Disconnect A.I.R. management valve from transaxle mount bracket and reposition.
25. Stud bolts through transaxle mount bracket to bell housing.
26. Lower car, lower transaxle to originally noted position.
27. Transaxle mount bracket upper stud bolts and bracket assembly using clockwise motion.
28. Lower transaxle left side to limit allowed by support fixture hooks (until hook upper end is flush with the top of the T-nut).
29. Raise vehicle.
30. Install drive axle boot seal protector J-34754.
31. Drive axle from transaxle, reposition to side (rear) and support properly.
NOTICE: Care must be taken to prevent tri-pot joints from being over extended when either end of the drive axle is disconnected. Over extension
of the joint may result in separation of internal components and possible joint failure.
32. Transaxle case side cover pan bolts and nuts.
33. Case side cover pan and gaskets.
