Allante V8-273 4.5L (1991)
Engine Support Fixture J-28467.
REMOVE OR DISCONNECT
Tools Required:
-
J-28467 Engine Support Fixture
-
J-34754 Drive Axle Boot Seal Protectors
1. Negative battery cable.
2. Air cleaner assembly.
3. Inner engine cooling fan assembly.
4. Vacuum hoses to cruise control servo and vacuum modulator.
5. Wire connectors to cruise control servo, distributor, engine oil sender, transaxle connector.
6. TV cable from both ends.
7. Vacuum modulator.
8. Install engine support fixture J 28467 and note position of left side hooks.
9. Raise vehicle, assure suitable support.
10. Left front tire and wheel assembly.
11. Right and left wheel housing lower splash shields.
12. Left stabilizer to control arm link, ball joint nut and cotter pin, separate left ball joint from steering knuckle.
13. Four transaxle mount to cradle and bracket nuts.
14. A/C compressor splash shield and #1 cradle mount insulator cover on left side, engine mount and dampener to cradle attachments.
15. Six right front cradle to cradle attaching bolts.
16. Two left stabilizer mount attaching bolts.
17. Two left rear cradle to cradle attaching bolts.
