Catera V6-3.0L VIN R (1997)
Electronic Brake Control Module: Service and Repair
REMOVAL PROCEDURE
Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to
observe this precaution could result in damage to the EBCM/EBTCM.
Notice: Avoid getting water, brake fluid or engine coolant into the socket of the EBCM/EBTCM connector. Failure to observe this precaution could
result in damage to the EBCM/EBTCM.
Important: A faulty EBTCM cannot be repaired. The EBTCM must be replaced as an assembly.
1. Disconnect the negative battery cable. Refer to Battery Disconnect Caution in Cautions and Notices.
2. Remove the hood contact switch (1).
3. Remove one power steering fluid reservoir screw (2).
4. Lay the fluid reservoir (3) to one side.
5. Remove one EBTCM cover screw (2).
6. Remove the EBTCM cover (1).