Catera V6-3.0L VIN R (1997)
8. Place a feeler gage between the clutch plate and the clutch rotor.
9. Tighten the hex portion of the hub and drive plate installer until the air gap between the clutch plate and clutch rotor is 0.40 mm (0.015 in).
Make sure that the air gap is even all around the clutch plate and hub assembly.
10. Remove the J33013-B.
11. Hold the clutch plate and hub assembly (2) with the J33027-A.
12. Install the compressor shaft nut. Tighten the compressor shaft nut to 17.5 Nm (13 lb. ft).
13. Spin the pulley rotor by hand to make sure the rotor is not rubbing against the clutch drive plate.
14. Remove the compressor from the J 41790.
15. Install the compressor into the vehicle.
