Catera V6-3.0L VIN R (1997)
Pull-To-Seat Connector
Follow the steps below in order to repair pull-to-seat type connectors.
1. Separate the connector halves.
2. Use the proper pick or removal tool in order to remove the terminal.
^
Gently pull the lead.
^
Insert the pick from the front of the connector into the canal.
^
Pry up on the tab.
^
Push on the lead in order to remove the lead.
3. If the terminal is to be reused, re-form the locking tang.
4. Make the repair.
^
Pull the terminal wire out of the connector body.
^
Cut the wire as close to the terminal as possible.
^
Strip 5 mm (3/26 in) of insulation from the wire.
^
Crimp the new terminal to the wire.
^
Solder the crimp with rosin core solder.
^
Carefully pull on the wire in order to draw the terminal into the connector body until it locks.
Push-to-Seat Connector
Connector Repairs: Push-To-Seat Connector
Follow the steps below in order to repair push-to-seat connectors.
1. Remove the Terminal Position Assurance (TPA) device, the Connector Position Assurance (CPA) device, and/or the secondary lock.
Connector Repairs: Push-To-Seat Connector
2. Separate the connector halves.
3. Use the proper pick or removal tool (1) in order to release the terminal.