Catera V6-3.0L VIN R (1997)
Body Control Module: Service and Repair
REMOVAL PROCEDURE
Body Control Module Replacement: Removal Procedure
Body Control Module Replacement: Removal Procedure
NOTE: The Body Control Module (BCM) electrical connectors are designed with tabs and slots that allow the connectors to only fit one way.
The connectors do not require excessive force if being installed correctly. Installing the connectors with the wrong mating half or upside down can
cause damage to the connector the BCM, or other vehicle components or systems.
1. Turn the ignition switch to the OFF position.
2. Disconnect the negative battery cable
3. Remove the right hinge pillar trim finish panel.
4. Gently separate the retainer (2) from the BCM (1).
5. Slide the BCM (1) out of the guides (3).
6. Remove the BCM from the mounting position.
