Catera V6-3.0L VIN R (1997)
Installation Procedure
1. Securely attach the CKP sensor pigtail to the lower end of the pull wire.
2. Pass the pigtail connector between the oil cooler lines and the engine block.
3. Using the pull wire as a guide, pull the sensor pigtail along the top of the oil cooler lines and around to the rear of the engine. Use the pull wire to
pull the pigtail into position.
4. Disconnect the pull wire from the sensor pigtail.
5. Connect the sensor pigtail to the harness connector.
6. Thoroughly clean the mating surfaces of the CKP sensor and the engine block.
7. Install the CKP sensor with a new O-ring seal into the engine block.
8. Install the fastening bolt (1) for the CKP sensor.
9. Check the harness for proper routing. Make sure that the wiring cannot come in contact with the exhaust manifold.
10. Tighten the oil cooler lines at the engine block.
11. Install the oil filter.
12. Lower the vehicle.
13. Recheck the engine oil level.
