CTS-V V8-6.0L VIN U (2006)
13. Remove the intermediate brake hose assembly mounting nuts (1) from the studs.
14. Remove the intermediate brake hose assembly (2) from the vehicle.
Installation Procedure
1. Install the intermediate brake hose assembly (2) to the mounting studs.
Notice: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.
2. Install the intermediate brake hose assembly mounting nuts (1) to the mounting studs.
Tighten the intermediate brake hose assembly mounting nuts to 14 Nm (124 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Remove the caps and/or plugs from the (2) BPMV to intermediate brake pipe fittings.
4. Connect the (2) BMPV brake pipe fittings to the intermediate brake hose assembly.
5. Remove the rubber plug from the brake hose to caliper bolt hole of the brake caliper.
6. Assemble the brake hose (2), the NEW copper brake hose gaskets (3), and the brake hose bolt (4) to the brake hose (2).
Important: Install NEW copper brake hose gaskets.
