CTS-V V8-6.0L VIN U (2006)
7. Install the brake hose (2) to caliper bolt (4) to the brake caliper (1).
Tighten the brake hose to caliper bolt to 50 Nm (37 ft. lbs.).
8. Remove the rubber cap and/or plug from the crossover brake pipe end.
9. Using a flat-bladed tool, install the brake hose retainer (2) to the rear frame assembly.
10. Connect the crossover brake pipe fitting (1) to the intermediate brake hose assembly (3).
Tighten the brake pipe fittings to 18 Nm (13 ft. lbs.).
11. Bleed the hydraulic brake system.
12. Install the tire and wheel assembly.
13. Lower the vehicle.
CTS-V
Brake Hose Replacement - Intermediate (CTS-V)
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
Important: The intermediate brake hose assembly is serviced as an assembly.
2. Remove the right rear tire and wheel assembly.
3. Clean all dirt and foreign material from the brake hose and the brake pipe fittings.
4. Disconnect the crossover brake pipe fitting (1) from the intermediate brake hose assembly (3) and cap or plug the brake pipe fitting end.
Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and/or contamination.
5. Lift the retaining clip (2) over the end of the brake hose.
6. Using a flat-bladed tool, remove the brake hose retainer (2) from the rear frame assembly.
7. Disconnect the (2) brake pressure modulator valve (BMPV) brake pipe fittings from the intermediate brake hose assembly and cap or plug the
brake pipe fitting ends.
