CTS-V V8-6.0L VIN U (2006)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve (BPMV) Bracket Replacement
Brake Pressure Modulator Valve (BPMV) Bracket Replacement (CTS-V)
Removal Procedure
1. Turn OFF the ignition.
Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
2. Remove the brake pressure modulator valve (BPMV) from the frame.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the 4 BPMV bracket to frame mounting bolts (2).
5. Remove the BPMV mounting bracket (1) from the frame.
Installation Procedure
1. Install the BPMV mounting bracket (1) to the frame.
Notice: Refer to Fastener Notice.
2. Install the 4 BPMV mounting nuts (2).
Tighten the BPMV bracket mounting nuts to 12 Nm (106 inch lbs.).
3. Install the brake pressure modulator valve to the BPMV bracket.
