CTS-V V8-6.0L VIN U (2006)
1. Loosen the jam nut on the outer tie rod.
2. Rotate the inner tie rod to the required toe specification setting. Refer to Wheel Alignment Specifications.
Notice: Care must be taken that the boots are not twisted when rotating the inner tie rods, or damage to the boots may result.
3. Tighten the jam nut to the outer tie rod.
^
Tighten the nut to 75 Nm (55 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
4. Check the toe setting after tightening. Refer to Wheel Alignment Specifications.
5. Re-adjust the toe setting if necessary.
Rear Camber Adjustment
^
Tools Required
-
J 45845 Caster and Camber Adjusting Tool
1. Install J 45845 to the lower control arm and the frame.
2. Loosen the lower control arm to frame bolt.
3. Adjust the camber angle by turning the turnbuckle on J 45845 until the specifications have been met.
^
Tighten the bolt to 150 Nm (111 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
4. Verify that the camber is still with specifications. Refer to Wheel Alignment Specifications.
5. Adjust the rear toe. Refer to Rear Toe Adjustment.
Rear Toe Adjustment
