cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Scan Tool Does Not Communicate with Class 2 Device|Page 8639 > < Scan Tool Does Not Communicate with Class 2 Device|Page 8637
Page 10
background image

-> The theft deterrent control module (VTD)
-> The TV antenna module
-> The vehicle communication interface module (VCIM)

3. The following DTCs may be retrieved with a history status, but are not the cause of the present condition.

-> U1300
-> U1301
-> U1305

6. A state of health DTC with a history status may be present along with a U1000 code having a current status. This indicates that the malfunction

occurred when the ignition was ON.

7. Data link connector terminals 2 and 5 provide the connection to the class 2 serial data circuit and the signal ground circuit respectively.

10. This step takes out from the class 2 bus the modules connected to splice pack SP300, except the SDM and the DIM.

11. This step takes out from the class 2 bus the modules connected to splice pack SP303, except the RIM.

13. This test isolates the class 2 serial data circuit between DLC and DIM.

18. This test localizes the class 2 serial data circuit of the suspected bus, that is shorted.

22. If there are no current DTCs that begin with a "U", the communication malfunction has been repaired.

23. The communication malfunction may have prevented diagnosis of the customer complaint.

Scan Tool Does Not Communicate with Class 2 Device|Page 8639 > < Scan Tool Does Not Communicate with Class 2 Device|Page 8637