CTS-V V8-6.0L VIN U (2006)
Air Flow Meter/Sensor: Service and Repair
MASS AIRFLOW SENSOR/INTAKE AIR TEMPERATURE SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the MAF/IAT sensor electrical connector (1).
2. Remove the air cleaner outlet duct assembly.
3. Loosen the MAF/IAT clamp (2).
4. Remove the MAF/IAT sensor from the air cleaner outlet duct. Note the position of the MAF/IAT sensor.
NOTE:
-
Handle the MAF sensor carefully.
-
Do not drop the MAF sensor in order to prevent damage to the MAF sensor.
-
Do not damage the screen located on the air inlet end of the MAF.
-
Do not touch the sensing elements.
-
Do not allow solvents and lubricants to come in contact with the sensing elements.
-
Use a small amount of a soap based solution in order to aid in the installation.
INSTALLATION PROCEDURE
1. Carefully install the MAF/IAT sensor to the air cleaner outlet duct. Ensure that sensor is clocked properly.
NOTE:
-
Handle the MAF sensor carefully.
-
Do not drop the MAF sensor in order to prevent damage to the MAF sensor.
-
Do not damage the screen located on the air inlet end of the MAF.
-
Do not touch the sensing elements.