CTS-V V8-6.0L VIN U (2006)
Steering Angle Sensor: Service and Repair
Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement
Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement
Tools Required
^
J21854-01 Pivot Pin Remover
Removal Procedure
1. Caution: Refer to SIR Caution in Service Precautions.
Disable the SIR system. Refer to Restraint System Disabling and Enabling Zone 3.
2. Remove the steering column from the vehicle.
3. Remove the turn signal switch housing.
4. Remove the tilt spring only.
5. Remove 2 pivot pins (1) from the steering column support assembly using J21854-01.
6. Remove the boot seal (5).
7. If sensor is not present, remove the following:
1. The steering shaft seal (4)
2. The sensor retainer (3)
8. If sensor is present, remove the following:
1. The sensor locator (2)
2. The sensor assembly (1)
Installation Procedure
