CTS-V V8-6.0L VIN U (2006)
3. The swage ring is swaged using J41048 by the following method:
1. Position the outboard end of the halfshaft assembly (1) in J41048.
2. Align the swage ring.
3. Place the top half of J41048 on the lower half of J41048.
4. Insert the bolts (2) and tighten by hand until snug.
Tighten each bolt 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
Notice: Do not cut through the wheel drive shaft inboard seal during service. Cutting through the seal may damage the sealing surface of the
housing and the tripot bushing. Damage to the sealing surface may lead to water and dirt intrusion and premature wear of the constant velocity
joint.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Align the following items during this procedure:
^
The outboard seal (1)
^
The halfshaft bar
^
The swage ring
