CTS-V V8-6.0L VIN U (2006)
Transmission Mount: Testing and Inspection
Aisin AY6 Transmission Mount Inspection
Transmission Mount Inspection
1. Notice: In order to avoid oil pan damage and possible engine failure, insert a block of wood that spans the width of the oil pan bottom between
the oil pan and the jack support.
Raise and support the vehicle. Refer to Vehicle Lifting.
2. Important: Before replacing any transmission mount due to suspected fluid loss, verify that the source of the fluid is the transmission mount, not
the engine, transmission or accessories.
Raise the transmission in order to remove the weight from the transmission mount and create slight tension in the rubber.
3. Observe the transmission mount while raising the transmission. Replace the transmission mount if the transmission mount exhibits any of the
following conditions:
^
The hard rubber surface is covered with heat check cracks.
^
The rubber is separated from the metal plate of the transmission mount.
^
The rubber is split through the center of the transmission mount.
4. If there is movement between the metal plate of the transmission mount and its attaching points, lower the transmission on the transmission mount.
Tighten the bolts or nuts attaching the transmission mount to the frame or transmission mount bracket. Refer to Transmission Mount Replacement.
5. Lower the vehicle.
