CTS V6-2.8L (2006)
Seat Cushion: Service and Repair
Front Seat Cushion Replacement
FRONT SEAT CUSHION REPLACEMENT
REMOVAL PROCEDURE
1. Disable the SIR System. Refer to SIR Disabling and Enabling driver's seat and SIR Disabling and Enabling and passenger seat.
CAUTION: Refer to SIR Caution in Service Precautions.
2. Move the seat to the full forward position.
3. Remove the retaining nuts (1) securing the seat cushion to the seat adjuster assembly.
4. Lift the front of the seat cushion upwards.
5. Remove the power seat switches.
6. Disconnect the wiring harness fastener and retainers securing the wiring harness to the bottom of the seat cushion frame.
NOTE: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.
7. Pull the cushion forward in order to remove the seat cushion from the seat adjuster assembly.
INSTALLATION PROCEDURE
1. Insert the seat cushion locators, at the rear of the seat cushion frame, into the rectangular openings in the seat adjuster assembly.
2. Secure the wiring harness to the seat cushion frame in the same position in which it was removed.
3. Install the power seat switches.
4. Lower the front of the seat cushion down into position onto the seat adjuster assembly.
5. Install the seat cushion nuts (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nuts (1) to 10 N.m (88 lb in).
6. Enable the SIR. Refer to SIR Disabling and Enabling driver's seat and SIR Disabling and Enabling and passenger seat.
