CTS V6-2.8L (2006)
4. Disconnect the brake hose (3) from the crossover pipe fitting (1).
Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and/or contamination.
5. Lift the retaining clip over the end of the brake hose.
6. Using a flat-bladed tool, remove the brake hose retainer (2) from the brake hose (3).
7. Remove the brake hose (1) from the frame assembly (2).
8. Remove the brake hose to caliper bolt (4) from the brake caliper (1).
9. Remove the brake hose (2) from the vehicle.
10. Place a shop towel on a hard surface.
11. Tap the threaded end of the brake hose to caliper bolt (4) on the shop towel to remove the gasket (3) from the bolt.
12. Remove and discard the two copper brake hose gaskets (3). These gaskets may be stuck to the brake caliper (1) and/or the brake hose end (2).
13. Install a rubber plug into the brake hose to caliper bolt hole of the brake caliper.
Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and/or contamination.
Installation Procedure
Notice: When installing the left rear brake hose to the caliper, the brake hose must be installed with the body of the hose positioned downward. The
