CTS V6-2.8L (2006)
17. Rotate the EBCM connector tab (2) up to the unlocked position.
18. Disconnect the EBCM electrical connector (1) from the EBCM (3) and position out of the way.
Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
19. Remove the 6 BPMV mounting bolts from under the mounting bracket.
20. Remove the EBCM/BPMV assembly from the BPMV bracket.
21. Remove and discard the 4 EBCM to BPMV screws.
22. Clean the surface of the EBCM/BPMV assembly.
23. Remove the EBCM (1) from the BPMV (2).
Installation Procedure
1. Clean the seal surface of the BPMV.
2. Install the EBCM (1) to the BPMV (2).
3. Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
