CTS V6-2.8L (2006)
Parking Brake Pedal: Service and Repair
RHD
Park Brake Pedal Assembly Replacement (RHD)
Removal Procedure
The automatic adjustment park brake pedal assembly and the front park brake cable are serviced as a unit. The front park brake cable has no threads
and is not adjustable.
1. Raise and suitably support the vehicle.
2. Pull down on the intermediate park brake cable near the park brake connector (2).
3. Remove the front park brake cable (3) from the park brake cable connector (1).
4. Remove the park brake cable guide bolt (2).
5. Remove the park brake cable guide nut (1).
6. Disconnect the park brake cable retainer from the floor pan by compressing the retaining tabs and pushing forward.
7. Lower the vehicle.
8. Remove the right closeout/insulator panel to access the park brake lever assembly.
9. Remove the right knee bolster.
10. Remove the left front carpet retainer.
11. Pull the carpet back in order to expose park brake cable.
12. Remove left closeout/insulator panel to access the park brake lever assembly.
13. Remove the left knee bolster.
14. Remove the left front carpet retainer.
15. Pull the carpet back in order to expose park brake cable.
16. Disconnect the electrical connector from the park brake warning lamp switch.
