CTS V6-2.8L (2006)
41.
Route the vacuum pump power wire with the I/P harness wires (2) and carefully insert the vacuum pump power wire terminal into cavity 30 (1) of
the I/P harness connector.
42.
Install the terminal lock.
43.
Tape the vacuum pump power wire to the I/P harness wires to ensure that it will not get pinched.
44.
Install the white plastic I/P harness connector cover.
45.
Reseal the I/P harness rubber pass-thru grommet to the corrugated conduit interface using electrical tape.
46.
Install the electrical center and screws.
Tighten
Tighten the screws to 9 N.m (80 lb in).
47.
Connect the engine harness to the electrical center.
48.
Connect the body harness to the electrical center.
49.
Connect the positive battery cable to the electrical center.
Tighten
Tighten the nut to 15 N.m (11 lb-ft).