CTS V6-2.8L (2006)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module (EBCM) Replacement (CTS)
Removal Procedure
1. Turn OFF the ignition.
Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
2. Thoroughly clean all of the contaminants from and around the EBCM assembly.
Important: The area around the electronic brake control module (EBCM) must be free from loose dirt to prevent contamination of dissembled
ABS components.
3. Press the retainer in the EBCM electrical connector (1).
4. Rotate the EBCM connector tab (2) to the unlocked position.
5. Disconnect the EBCM electrical connector (1) from the EBCM (3) and position out of the way.
6. Remove and discard the 2 upper EBCM to brake pressure modulator valve (BPMV) screws (1).
7. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
8. Remove the front air deflector.
9. Remove and discard the 2 lower EBCM to brake pressure modulator valve (BPMV) screws (1).
10. Lower the vehicle.
