CTS V6-2.8L (2006)
Important: Ensure not to distort or bend the engine mount heat shield.
7. Remove the left engine mount bracket retaining bolts.
8. Remove the left engine mount bracket.
Installation Procedure
1. Install the left engine mount bracket.
Notice: Refer to Fastener Notice.
2. Install the left engine mount bracket retaining bolts.
Tighten the bolts to 60 N.m (44 lb ft).
3. Install the engine mount to the vehicle.
4. Install the upper engine mount retaining nut.
Tighten the nut to 80 N.m (59 lb ft).