CTS V6-2.8L (2006)
Important: Ensure not to distort or bend the engine mount heat shield.
8. Remove the right engine mount bracket mounting bolts.
9. Remove the engine mount bracket from the vehicle.
Installation Procedure
1. Install the engine mount bracket to the vehicle.
Notice: Refer to Fastener Notice.
2. Tighten the M10 engine mount bracket mounting bolts.
Tighten the bolts to 60 N.m (44 lb ft).
3. Tighten the M 8 engine mount bracket mounting bolt.
Tighten the bolt to 38 N.m (28 lb ft).
4. Install the starter.