CTS V6-2.8L (2006)
Cornering Lamp: Service and Repair
HEADLAMP ASSEMBLY OR HEADLAMP BULB AND/OR CORNERING, SIDEMARKER, PARK, TURN SIGNAL BULB
REPLACEMENT
REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the push-pin retainers on the air deflector to allow access to fascia extension retainers.
3. Open the hood.
4. Remove the push-pin retainers that secure the appropriate side of the grille and fascia to the upper tie bar.
5. Remove the first push-pin retainer past the center in order to allow the grille to flex.
6. Remove the front fascia extension.
7. Remove the bolt (2) that secures the front fascia to the fender.
8. Loosen the bolt (1) that attaches the front fascia to the fender.
9. Pull the front fascia forward to align the fascia studs with enlarged portion of the hole within the key slot in the fender.
10. Gently pull the front fascia downward to disengage it from the front fender.
11. Remove the 3 bolts that secure the headlamp to the vehicle.
12. Disengage headlamp washer hose, if equipped.
