CTS V6-2.8L (2006)
19. Remove the knuckle from the vehicle.
20. Remove the wheel bearing/hub bolts.
21. Remove the knuckle and backing plate from the wheel bearing/hub.
Installation Procedure
1. Install the knuckle and backing plate to the wheel bearing/hub.
2. Install the wheel bearing/hub mounting bolts.
Tighten the bolts to 125 N.m (92 lb ft).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the knuckle to the vehicle.
4. Install the adjustment link to knuckle mounting bolt.
Important: Loosely install all fasteners before tightening.