CTS V6-3.2L VIN N (2003)
2. Align the steering control switch assembly engagement tabs to the steering wheel.
Push in on the steering wheel control switch assembly in order to secure the control switch assembly to the steering wheel.
Notice: Refer to Fastener Notice in Service Precaution.
3. Install the steering wheel control harness retainer and screw.
^
Tighten the screw to 2.3 Nm (20 inch lbs.).
4. Install the steering wheel control switch assembly screws.
^
Tighten the screws to 2.3 Nm (20 inch lbs.).
5. Connect the steering wheel control electrical connector.
6. Secure the connector to the retaining clip.
7. Install the steering wheel inflatable restraint module.
8. Enable the SIR.