CTS V6-3.2L VIN N (2003)
9. Install the three remaining tumblers (11) into the tumbler slots located at key cut positions 5, 7 and 9.
10. Inspect for correct loading of the tumblers (11) by inserting the matching key into cylinder (10). All tumblers (11) should be flush with the outside
diameter of the cylinder (10).
11. Lightly lubricate the tumbler (11) surfaces using the provided lubrication.
12. Install the sleeve (5) into the case (12). Ensure the sleeve (5) is oriented and inserted so that the back of the sleeve is flush with the back of the
case (4).
13. With the matching key fully inserted into the coded cylinder, install the coded cylinder into the case assembly (12).
14. Remove the matching key being careful to keep the coded cylinder (10) fully inserted into the case assembly (12).
15. Insert one shutter spring (9) each into the two shutter spring holes located on the front face of the cylinder (10).
16. Install the shutter assembly (8) into the recessed area in the front face of the cylinder (10). Ensure that the ends of the pin on the shutter assembly
(8) are positioned in the pin cavities located on the front face of the cylinder (10).
17. Install the lock cylinder cap (7) by aligning the rectangular hole in the cap with the drain hole located on the bottom of the case (12). Snap the cap
(7) into place with light hand pressure. Insure the cap is securely retained on the case and that the shutter springs (9) is push in the shutter assembly
(8) up against the inside surface of the cap.
18. Install clutch (4) onto rear end of cylinder (10). Ensure the clutch (4) mates with the engagement tab on the cylinder (10).
19. Set return spring (3) onto rear of cylinder assembly with the first leg engaged with the clutch (4).
20. Hook second leg of return spring (3) onto opposite clutch (4) finger by compressing and rotating spring leg counter-clockwise. The return spring
(3) will need to be help in place until the lever (2) and retaining ring (13) are properly installed.
21. Install the appropriate lever (2) right or left onto the end of the cylinder (10) so that the lever (2) engages the fingers of the clutch (4). The ID
stamp of the lever (2) should face toward the cap (7) at the front of the cylinder assembly.
22. Install the retaining ring (13 in the groove at the end of the cylinder to secure the lever (2) to the cylinder.
23. Snap the appropriate rod retainer (1) right or left into the hole in the lever (2).
