CTS V6-3.2L VIN N (2003)
Important: DO NOT allow the sealer to get into the oil journal of the cap.
4. Apply a small amount of GM P/N 1052942 (Canadian P/N 10953466), or equivalent on the forward edge of the front bearing caps to ensure an
adequate seal between the bearing cap and the cylinder head.
5. Install the camshaft bearing caps according to the identification marks.
Camshaft Bearing Cap Bolt Torque Sequence
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
6. Install the camshaft bearing cap bolts.
6.1.
Alternately hand tighten the camshaft bearing cap bolts in sequence a few turns at a time until all caps are fully seated.
