CTS V6-3.2L VIN N (2003)
3. Apply a thin coat of silicone sealer GM P/N 12346286 (Canadian P/N 10953472)1 to the corners of the front and back of the seals.
4. Apply a 3 mm (0.12 inch) bead of silicone sealer GM P/N 12346286 (Canadian P/N 10953472), at the front and rear of the camshaft cover
between the seals.
5. Position the camshaft cover (2) to the cylinder head, aligning the datum with the hole in the cylinder head.
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
6. Install the camshaft cover bolts (1).
Tighten the camshaft cover bolts to 8 Nm (71 inch lbs.).
7. Install the knock sensor wire harness bracket and bolt.
Tighten the knock sensor wire harness bracket bolt to 8 Nm (71 inch lbs.).
