CTS V6-3.2L VIN N (2003)
Air Bag(s) Arming and Disarming: Service and Repair
Zone 5
1. Remove the key from the ignition switch.
2. Connect the I/P module yellow connector (1) to the vehicle harness yellow connector (2).
3. Install the CPA to the I/P module yellow connector (2).
4. Install the right sound insulator to the I/P (3).
5. Install the SIR fuse into the right rear fuse center (1).
6. Install the right rear fuse center cover.
7. Install the rear seat.
8. Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
9. Perform the Restraint Systems Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic
System Check - Restraint Systems.