CTS V6-3.2L VIN N (2003)
15. Pull the right side transmission support down only enough to allow removal of the chassis fuel hose/pipes.
16. Partially lower the hoist only enough to simultaneously gain access to both the front and rear portions of the chassis fuel hose/pipes.
17. With the aid of an assistant, carefully guide the chassis fuel hose/pipes down through the engine compartment, removing from the bottom.
INSTALLATION PROCEDURE
1. Clean any of the contamination from the male line ends and apply a few drops of clean engine oil.
2. With the aid of an assistant, carefully guide the chassis fuel hose/pipes up through the engine compartment into position.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Pull the right side transmission support down only enough to allow installation of the chassis fuel hose/pipes.
5. Install the bolts securing the transmission support to the underbody.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
