CTS V6-3.2L VIN N (2003)
Knock Sensor: Description and Operation
Bank 1 And Bank 2 Knock Sensors (KS)
The Knock Sensor (KS) System detects engine detonations. The KS module is employed in the Engine Control Module (ECM). The ECM will retard the
spark timing based on the signals from the KS module. The KS produce an AC voltage that is sent to the KS module. The amount of the AC voltage
produced is proportional to the amount of knock.
The control module reads the voltage of the sensor during the 45 degrees after cylinder 2, 4, or 6 has fired and the voltage of the sensor during the 45
degrees after cylinder 1, 3, or 5 has fired.
If knock occurs in any of the cylinders, the ignition will be retarded by 3 degrees for that particular cylinder. If the knocking then stops, the ignition will
be restored to what it was before in steps of 0.75 degrees.
Should knocking continue in the same cylinder in spite of the ignition being retarded, the control module will retard the ignition an additional step of 3
degrees, and so on, up to a maximum of 12.75 degrees. The ignition will also be retarded at high ambient temperatures in order to counteract knocking
tendencies provoked by high intake air temperatures.
