CTS V6-3.2L VIN N (2003)
Steering Angle Sensor: Service and Repair
Steering Wheel Position Sensor Replacement
Steering Wheel Position Sensor Replacement
^
Tools Required
-
J 21854-01 Pivot Pin Remover
Removal Procedure
Caution: Refer to SIR Caution in Service Precautions.
1. Disable the inflatable restraint steering wheel module.
2. Remove the turn signal switch housing.
3. Remove the tilt spring only.
4. Remove 2 pivot pins (1) from the steering column support assembly using J21854-01.
5. Remove the boot seal (5).
6. If sensor not present, remove the following:
6.1.
The steering shaft seal (4)
6.2.
The sensor retainer (3)
7. If sensor is present, remove the following
7.1.
The sensor locator (2)
7.2.
The sensor assembly (1)
Installation Procedure