CTS V6-3.2L VIN N (2003)
4. Install the J 45845 to the lower control arm and the frame.
5. Loosen the lower control arm adjustment nuts.
Notice: Refer to Fastener Notice in Service Precaution.
6. Adjust the caster and the camber angle by repositioning the lower control arm until the specifications have been met. When the adjustments are
complete, hold the lower control arm in position so that the specifications do not change while tightening the lower control arm adjustment bolts.
^
Tighten the lower control arm adjustment bolts to 135 Nm (100 ft. lbs.).
7. Verify that the caster and the camber are still within specifications. When the caster and camber are within specifications, adjust the toe.
Front Toe Adjustment
1. Loosen the jam nut on the outer tie rod.
Notice: Care must be taken that the boots are not twisted when rotating the inner tie rods, or damage to the boots may result.
2. Rotate the inner tie rod to the required toe specification setting.
Notice: Refer to Fastener Notice in Service Precaution.
3. Tighten the jam nut to the outer tie rod.
^
Tighten the nut to 75 Nm (55 ft. lbs.).
4. Check the toe setting after tightening.
5. Re-adjust the toe setting if necessary.
Rear Camber Adjustment
^
Tools Required
-
J 45845 Caster and Camber Adjusting Tool
