CTS V6-3.2L VIN N (2003)
14. Remove the power steering gear mounting bolts.
15. Remove the power steering gear through the right wheel opening.
16. Transfer the outer tie rods if replacing the power steering gear.
Installation Procedure
1. Install the power steering gear through the left wheel opening.
Notice: Refer to Fastener Notice in Service Precaution.
2. Install the power steering gear mounting bolts.
^
Tighten the power steering gear mounting bolts to 95 Nm (70 ft. lbs.).
3. Install the power steering return hose to the steering gear retaining bolt.
^
Tighten the bolt to 9 Nm (80 inch lbs.).
4. Install the stabilizer shaft.
Important: Install new seals on the power steering pressure and return lines.
